First of all, we start from the characteristics of the pipeline began:
1. The speed of the transport process is correct and stable, can guarantee the accurate synchronous transmission;
2, made of a specific aluminum, the assembly is very convenient.
3, simple structure, the appearance of fine, practical and no noise;
4. Shipping volume is large, can load a larger weight;
5, high automation, multi-functional,
6. Convenient accumulation of transport, you can do assembly line or for the storage of goods transport;
7. Equipment performance is guaranteed, can adapt to any bad places (high temperature, dust) work,
8. Chain plate conveyor is a chain plate as a traction and carrier transport things, the chain can be the usual sleeve roller conveyor chain, you can also use some other special chain;
Pipeline of the various parts of our how to carry out maintenance and normative operation, pipelines and other transportation equipment is not only maintenance, the work of the workers at the time of operation norms, the only way to make the transmission line is running normally.
Also note that maintenance is not only the maintenance of hardware, but also pay attention to the regular operation of the operator. The graphic design of the pipeline should ensure that the parts have the shortest transport route, the production workers are easy to operate, the auxiliary service department is working conveniently, the most efficient use of the production area, and the interconnection between the assembly lines. To meet these requirements, in the layout of the pipeline should be considered in the form of pipelines, pipelines to install the work of the arrangement of the method and so on.
1, the head of the motor maintenance and maintenance of the transformer: Do not enter the water inside the motor, once the water will lead to damage to the motor insulation equipment does not run up.
2, the chain of maintenance and maintenance: the chain needs more observation, ground with butter and lubricants, due to long-term operation of the chain, the lubricating liquid will evaporate, resulting in noise increases, bias crawling and other issues.
3, the pipeline head of the gear box repair and maintenance: the first time after the use of a quarter of the gear box after the excess oil put all finished, and then use gasoline, diesel, etc. to the inside of the gear box to take a bath, and then the new Of the lubricating oil added to the middle of the observation window on the line. The next year after every year to operate it again. (We need to note: too little lubricant will cause the gear box noise and overheating, and even the gear box of the scrapped, and each time the lubricating oil can not be more than the middle of the observation window, more than too much will cause the gear box overheating, The motor load is too large and the protection switch is disconnected. |
